There are a few things to keep in mind during the Shingle Roofing Installation process. First, choose your shingle color. Also, you will need to decide if you will install a ridge cap. Finally, make sure you nail the tiles into mortar, which will add additional structural support.
Choosing A Shingle Color
The shingle color of your roof is an important visual effect. You need to match the color of your roof to the overall look of your home. For example, a brown roof will look out of place on a white house. In addition, you should choose a color that is complimentary to the color of your home. If your home is yellow, a red roof will look out of place and may turn away potential buyers. So, you need to think about the color of your roof carefully.
A darker-colored roof will be more dramatic, but it will also look more imposing. It can balance the height and width of your home. Alternatively, a lighter-colored roof will draw the eye upward.
Choosing A Ridge Cap
Choosing a ridge cap is an important step in shingle roofing installation. The cap should overlap the field shingles and be secured using longer nails. Longer nails will penetrate more layers of the roof and anchor into the roof deck. The length of the shingle should be measured before nailing the ridge cap.
CertainTeed offers a life-time warranty for certain shingle roofs. This warranty covers blow-offs that are caused by wind. CertainTeed also increases its wind warranty to 130 mph.
Installing Shingles In The Field Of The Roof
When installing shingles, make sure to follow the manufacturers’ recommended pattern. Laying shingles can be tricky, but there are a few tricks you can use to make the task easier. Always stagger the seams. For example, if you’re installing shingles on a hip roof, run them long over the ridge, and then cut them short to fit the valleys.
Roofing shingles are installed in several overlapping layers to prevent water from entering crevices. Water that collects in these crevices can cause rot. Installing shingles on your roof properly will ensure that water runs off the roof safely.
Installing Shingles In The Valley
When installing shingles in the valley, you need to use the proper technique. The shingle edges should be positioned parallel to the valley line, and the shingles must be nailed along both the metal edge of the valley and the edge of the roof deck. In this way, you will prevent water from seeping in between the shingles.
The best way to install shingles in the valley is to install them on the side of the roof that is the lowest slope. Then, you will cut the shingles on the other side, making sure to make a clean line down the middle of the valley. You can also use a chalk line to guide your cuts.
Installing Shingles In The Hip
When installing shingles on the hip of your roof, it is important to line up the shingles with the ridge and edge of the roof. Then, place nails about one and a half inches from the top and side of the shingle. If the roof is located in an area where there is a lot of wind, you should add one additional nail at each spot.
Unlike a traditional roof, a hip roof is particularly susceptible to water damage, so make sure the roof has tin strips and flashing along the ridge. Then, lay your first shingle so that it lies even with the edge of the hip roof. After that, cut the shingles with the angles of the hip roof ridge.